F. Weis, M. Seipenbusch, G. Kasper

Journal of Nanoparticle Research, 2015, DOI: 10.1007/s11051-014-2824-1

An on-line method is described and validated to measure the thickness of coatings on gasborne nanoparticles. The method is essentially a tandem technique which measures the aerodynamic diameter of a particle twice - before and after coating - by a single-stage low-pressure impactor (SSLPI) for the same  mobility equivalent diameter preselected via differential mobility analyzer (DMA). A shell thickness is then derived from the change in effective particle density determined by the SS-LPI. The method requires a difference in mass density between carrier particle and coating material. Its theoretical sensitivity is shown to range between about 0.1 and 1 nm, depending on the density ratio. One advantage of this approach is that both DMA and SS-LPI are situated in series but downstream of the coating step, so as not to interfere with the coating process. The method was validated against transmission electron microscopy (TEM) measurements, using spherical silica–titania particles coated with conformal shells of molybdenum and bismuth oxide by chemical vapor deposition (CVD). For such spherical particles, the agreement with TEM was excellent. The technique was able to provide layer thicknesses for sub-nanometer layers barely or not resolved by TEM.
The paper also discusses the impact of ‘non-ideal’ phenomena such as the formation of doublet particles by coagulation, the effect of multiply charged particles, or the onset of homogeneous decomposition of the coating precursor. With supporting experimental data, it is shown that such phenomena can be interpreted reliably from certain features of the impactor penetration curve. The on-line method can thus be used for fast screening of process parameters and reliable process monitoring for gas-phase synthesis of composite nanopowders.